Enabling A Glbp Group - Cisco Nexus 7000 Series Configuration Manual

Configuring GLBP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

Enabling a GLBP Group

You can configure the virtual IP address on an interface to enable the GLBP group. You must configure
each gateway in the GLBP group with the same group number. The GLBP member can learn all other
required parameters from another GLBP member.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
Enable the GLBP feature (see the
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
config t
Example:
switch# config t
switch(config)#
Step 2
interface interface-type slot/port
Example:
switch(config)# interface ethernet
1/2
switch(config-if)#
Step 3
ip ip-address /length
Example:
switch(config-if)# ip 192.0.2.1/8
Step 4
glbp group-number
Example:
switch(config-if)# glbp 1
switch(config-if-glbp)#
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
18-14
config t
interface interface-type slot/port
ip ip-address/length
glbp group-number
ip [ip-address [secondary]]
show glbp [brief]
copy running-config startup-config
"Enabling the GLBP Feature" section on page
Purpose
Enters configuration mode.
Enters interface configuration mode.
Configures the IPv4 address for the interface.
Creates a GLBP group and enters GLBP configuration
mode.
Chapter 18 Configuring GLBP
18-7).
OL-20002-02