Functions, Codes And Symbols - ABB RED615 Technical Manual

Section 1
Introduction
1.4.3
28
To navigate between the options, use
• HMI menu paths are presented in bold.
Select Main menu/Settings.
• LHMI messages are shown in Courier font.
To save the changes in non-volatile memory, select Yes and press
• Parameter names are shown in italics.
The function can be enabled and disabled with the Operation setting.
• Parameter values are indicated with quotation marks.
The corresponding parameter values are "On" and "Off".
• IED input/output messages and monitored data names are shown in Courier font.
When the function starts, the START output is set to TRUE.

Functions, codes and symbols

All available functions are listed in the table. All of them may not be applicable to
all products.
Table 1: Functions included in the IEDs
Function
Protection
Three-phase non-directional overcurrent protection,
low stage, instance 1
Three-phase non-directional overcurrent protection,
low stage, instance 2
Three-phase non-directional overcurrent protection,
high stage, instance 1
Three-phase non-directional overcurrent protection,
high stage, instance 2
Three-phase non-directional overcurrent protection,
instantaneous stage, instance 1
Three-phase non-directional overcurrent protection,
instantaneous stage, instance 2
Three-phase directional overcurrent protection, low
stage, instance 1
Three-phase directional overcurrent protection, low
stage, instance 2
Three-phase directional overcurrent protection, high
stage
Three-phase non-directional overcurrent protection
that contains three independent phase-segregated
timers, low stage, instance 1
Three-phase non-directional overcurrent protection
that contains three independent phase-segregated
timers, low stage, instance 2
Three-phase non-directional overcurrent protection
that contains three independent phase-segregated
timers, high stage, instance 1
Three-phase non-directional overcurrent protection
that contains three independent phase-segregated
timers, high stage, instance 2
Three-phase non-directional overcurrent protection
that contains three independent phase-segregated
timers, instantaneous stage, instance 1
Three-phase directional overcurrent protection that
contains three independent phase-segregated timers,
low stage, instance 1
Table continues on next page
and .
IEC 61850 IEC 60617
PHLPTOC1 3I> (1)
PHLPTOC2 3I> (2)
PHHPTOC1 3I>> (1)
PHHPTOC2 3I>> (2)
PHIPTOC1 3I>>> (1)
PHIPTOC2 3I>>> (2)
DPHLPDOC1 3I> -> (1)
DPHLPDOC2 3I> -> (2)
DPHHPDOC1 3I>> ->
PH3LPTOC1 3I> (1)
PH3LPTOC2 3I> (2)
PH3HPTOC1 3I>> (1)
PH3HPTOC2 3I>> (2)
PH3IPTOC1 3I>>> (1)
DPH3LPDOC1 3I> -> (1)
1YHT530004D05 D
.
IEC-ANSI
51P-1 (1)
51P-1 (2)
51P-2 (1)
51P-2 (2)
50P/51P (1)
50P/51P (2)
67-1 (1)
67-1 (2)
67-2
51P-1 (1)
51P-1 (2)
51P-2 (1)
51P-2 (2)
50P/51P (1)
67-1 (1)
615 series
Technical Manual