Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8800 Series Administration Manual

Set Up Softkey Template
Step 10 Choose User Management > End Userand select a user.
Step 11 Navigate to the MLPP Authorization section and configure MLPP Authorization for a user.
The MLPP User Identification number must be composed of 6 to 20 numeric characters.
The MLPP Password must be composed of 4 to 20 numeric (0-9) characters
The Precedence Authorization level can be set to any standard precedence level from Routine to Executive
Override
Step 12 Select Save.
Step 13 Set up the MLPP DSCP for an End User.
The DSCP values for video streams can be configured for each precedence level in the QoS section of the
Service Parameters. All DSCP values include the decimal value in the setting.
Step 14 To add a third-party AS-SIP phone, choose Device > Phone > Add New
The phone Add list displays the third-party AS-SIP phone as an available choice.
The device configuration fields are the same as those for Cisco phones.
Set Up Softkey Template
Using Cisco Unified Communications Manager Administration, you can associate a maximum of 18 softkeys
with applications that are supported by the phone. Cisco Unified Communications Manager supports the
Standard User and Standard Feature softkey template.
An application that supports softkeys has one or more standard softkey templates associated with it. You
modify a standard softkey template by copying it, renaming it, and then updating the new template. You can
also modify a nonstandard softkey template.
The Softkey Control parameter shows if softkeys of a phone are controlled by the Softkey Template feature.
The Softkey Control parameter is a required field.
For more information about configuring this feature, see the documentation for your particular Cisco Unified
Communications Manager release.
The Cisco IP Phones do not support all the softkeys that are configurable in Softkey Template Configuration
on Cisco Unified Communications Manager Administration. Cisco Unified Communications Manager allows
you to enable or disable some softkeys in the control policy configuration settings. The following table lists
the features and the softkeys that can be configured on a softkey template, and identifies whether it is supported
on the Cisco IP Phones.
Cisco Unified Communications Manager allows you to configure any softkey in a softkey template, but
Note
unsupported softkeys do not display on the phone.

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

234
◦ When set to Forceful, preempt for reuse is enabled. Existing calls may be preempted to offer a
higher precedence call to the user.
◦ When set to Default, the setting from the common configuration or enterprise level is used.