Install Bracket - Cisco 8800 Series Administration Manual

• One phone bracket
• One wall bracket
• Four #10-12x1-inch Phillips-head screws with 4 anchors
• One sheet metal screw (not shown)
• Two #4-40x1/4-inch machine screws
• One 6-inch Ethernet cable
• One key if the bracket includes the optional lock

Install Bracket

Before You Begin
You need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
• Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack.
Procedure
Step 1 Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
a) Use the level to ensure that the bracket is level, then use a pencil to mark the screw holes.
b) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall.
c) Screw the anchor clockwise into the wall until it is seated flush.
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
Lockable Wall Mount Components for Phone
123