Honda Prelude 1993 Service Manual page 1384

Check continuity between body ground and each
terminal of both dash sensors.
TEST HARNESS B
07MAZ - SP00500
a lf there is continuity at any ol the terminals, go
t o s t e p 1 2 .
a lf there is no continuity at any terminal, go to
s t e p 1 3 .
Disconnect the cable reel 6-P connector from the
SRS main harness, then connect Test Harness C
{O7LAZ-SL4O3OO) only to the cable reel side oI
the 6-P connector.
o .
I
- \ l
7 . Check continuity between the No, 4 terminal and
body ground. and between the No. 5 terminal and
body ground.
lf there is continuity at either terminal. go to
step 8.
lf there is no continuity at either terminsl, the
SRS main harness is faulty. Replace it and
recheck the voltages according to the chart on
page 23-3O4.
{cont'd)
23-307