Draytek vigor2960 series User Manual page 381

4 . 1 3 . 1 .
4 . 1 3 . 1 .
This page allows you to configure bandwidth of data and voice signals transmission for
outgoing data and incoming data through hardware interface.
Note: The difference between Hardware QoS and Software QoS is that only one WAN
interface is supported by Hardware QoS. However, there are six WAN interfaces supported
by Software QoS.
Available parameters are listed as follows:
Item
QoS WAN
Status
Bandwidth
High/Medium/
Normal/Low
Apply
Cancel
Enter all of the settings and click Apply.
Vigor2960 Series User's Guide
3 H a r d w a r e Q o S
3 H a r d w a r e Q o S
Description
Use the drop down list to choose the WAN interface to apply
hardware QoS.
Enable – Click it to enable QoS for outgoing/incoming
traffic.
Disable – Click it to disable QoS for outgoing/incoming
traffic.
Type the number as the total transmission rate for the
outgoing /incoming data. The range can be set from 64 to
1000000 kbps.
Click the unit (Kbps or Mbps) for such rate.
It determines the weight for each queue. All queues in the
data group to be initialized with weights of zero, resulting in
a strict service to completion (STC) mechanism across all
queues.0.
Type the weight of queues in bytes, range from 0 to
1000000.
Click it to save and exit the dialog.
Click it to exit the dialog without saving anything.
373