Draytek vigor2960 series User Manual page 311

Dial-Out Through
Failover to
Idle Timeout
Server IP/Host
Name
PPTP User Name
PPTP Password
Local IP/Subnet
Mask
Remote IP/Subnet
Mask
Route/NAT Mode
Netbios Naming
Packet
Multicast via VPN
RIP via VPN
Vigor2960 Series User's Guide
Choose a wan profile to be used by such profile. Then, use
the default WAN IP or specify a WAN Alias IP for VPN
tunnel.
Choose a wan profile which will lead the data passing
through other WAN automatically when the selected WAN
interface (in Dial-Out Through) is failover.
When Always On is disabled, you have to type the value for
terminating the network connection.
Type the IP address or host name of PPTP server.
Type a user name for authentication in PPTP connection.
Type a password for authentication in PPTP connection.
Type the IP address and subnet mask of local host.
Type the LAN IP address and LAN subnet mask for the
remote host.
Specify the purpose for such profile.
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Some programs might send multicast packets via VPN
connection.

Enable – Click this button to let multicast packets pass
through the router.

Disable – This is default setting. Click this button to let
multicast packets be blocked by the router.

Enable – Click it to exchange routing information
protocol packets via VPN connection.

Disable – Disable such function. This is default setting.
303