Draytek vigor2960 series User Manual page 101

Default MAC
Address
MAC Address
IPv4 Protocol
Mode
IP Address
Subnet Mask
Connection
Detection Mode
Gateway IP
Address
Connection
Detection Interval
Connection
Detection Retry
DHCP Server
DHCP Start IP
DHCP End IP
DHCP DNS
Vigor2960 Series User's Guide
Enable – Click it to enable the default MAC address for such
profile.
Disable – Click it to type the MAC address manually for such
profile.
If Default MAC address is disabled, please specify a MAC
address manually with the format like "00:1d:aa:b2:69:80".
Display the fixed type (static) for the IPv4 protocol for such
profile.
Choose NAT or ROUTING as the operation mode for such
profile.
Type the IP address (with the format like 192.168.1.25) of the
router for the LAN profile.
Use the drop down list to choose a suitable mask for the LAN
profile.
Select a detecting mode for this LAN interface.
This feature is used to operate in coordination with Policy
Route profile. Vigor system can choose suitable router policy
through connection detection automatically.
It is available when ARP is selected as Connection Detection
Mode.
Type a public gateway address. Vigor router will detect the
destination IP specified here automatically when such LAN
profile is used. If the IP is not detected, the connection status
for LAN will be shown as "down".
It is available when ARP is selected as Connection Detection
Mode.
Assign an interval period of time for each detecting.
It is available when ARP is selected as Connection Detection
Mode.
Assign detecting times to ensure the connection of the LAN
interface. After passing the times you set in this field and no
reply received by the router, the connection of LAN interface
will be regarded as breaking down.
Enable – Click it to enable the DHCP server. The DHCP
server will assign the IP address randomly for the LAN user.
The range of the IP addresses must be defined in DHCP Start
IP and DHCP End IP.
Disable – Click it to disable the DHCP server.
Type an IP address as the starting point for DHCP server.
Type an IP address as the ending point for DHCO server.
Set the private IP address for DNS server. If this field is
blank, users on LAN will treat Vigor2960 as the DNS server.
93