Draytek vigor2960 series User Manual page 317

Netbios Naming
Packet
Multicast via VPN
RIP via VPN
If you choose IPsec as the Type in Step 1, you will get the following page:
Available parameters are listed as follows:
Item
Profile
Enable
WAN Profile
Local IP/Subnet
Mask
Local Next Hop
Vigor2960 Series User's Guide
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Some programs might send multicast packets via VPN
connection.

Enable – Click this button to let multicast packets pass
through the router.

Disable – This is default setting. Click this button to let
multicast packets be blocked by the router.

Enable – Click it to exchange routing information
packets via VPN connection.

Disable – Disable such function. This is default setting.
Description
Display the name of the VPN profile.
Check this box to enable such profile.
Choose a WAN profile to be used by such profile.
Type the IP address and subnet mask of local host.
Specify the gateway for WAN interface. Usually, use the
309