Draytek vigor2960 series User Manual page 314

Local IP/Subnet
Mask
Remote IP/Subnet
Mask
Route/NAT Mode
Netbios Naming
Packet
Multicast via VPN
RIP via VPN
5. Fill in the required information on this page and click Finish. Later, a new profile has
been created.
Type the IP address and subnet mask of local host.
Type the LAN IP address and LAN subnet mask for the
remote host.
Specify the purpose for such profile.
Enable – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.
Disable –When there is conflict occurred between the hosts
on both sides of VPN Tunnel in connecting, such function
can block data transmission of Netbios Naming Packet inside
the tunnel.
Some programs might send multicast packets via VPN
connection.

Enable – Click this button to let multicast packets pass
through the router.

Disable – This is default setting. Click this button to let
multicast packets be blocked by the router.

Enable – Click it to exchange routing information
packets via VPN connection.

Disable – Disable such function.
306
Vigor2960 Series User's Guide