Sony Betacam SX DNW-A100 Maintenance Manual page 72

1-19. Installation of BKNW-105
Check [through step (37) ]
(32)Wear the headphones.
(33)Select the EXT as a player device. (Press the EXT
button while pressing the PLAYER button.)
(34)Press the PLAY button to playback the file that is
recorded in step (29), and check that the all audio level
meter (CH-1/2/3/4) read _20 dB FS.
(35)Switch to MONITOR by audio selection function
selector switch.
(36)Check that the noise is not heard while switching the
CH-1/2/3/4.
(37)Press the STOP button to stop the playback, and
remove the BNC cables that were connected in steps
(22) and (23).
n
Be sure to remove the BNC cable before going to the
next step.
Handling after check [through step (42)]
(38)Press the MENU button to enter the setup menu mode.
(39)Set ITEM-710 INTERNAL VIDEO SIGNAL GEN-
ERATOR and ITEM-808 INTERNAL AUDIO
SIGNAL GENERATOR to "OFF". Set ITEM-322
AUDIO SIGNAL FLOW D-D to "int".
(40)Press the SET button to exit the setup menu mode.
(41)Set S1100-1 on the SS-63 board to its previous state.
(42)Delete the file that is recorded. (Refer to "Chapter 5.
Editing Using the Built-in Hard Disk" of the operation
manual.)
1-60
DNW-A100/A50/A45
DNW-A100P/A50P/A45P