Installation Of Bknw-103; Procedure - Sony Betacam SX DNW-A100 Maintenance Manual

1-17. Installation of BKNW-103

By installing the SDTI Input Kit BKNW-103 in the unit,
SDTI INPUT signal supplied from the external equipment
is recorded to the hard disk drives at high-speed.
BKNW-103 can be installed in the DNW-A100/A100P
only.
Component
. SDTI input board (CP-300 board)
. Flat cable (30-pin)
. Power harness
. Screw (PSW 3 x 6)
. Screws (BVTT 3 x 6)

1-17-1. Procedure

[|Importance|] [|Importance|]
[|Importance|] [|Importance|] [|Importance|]
Check the ROM version (SY1, SY2 and SSX) of the unit
by C40: ROM VERSION of the maintenance mode before
starting the installation.
SY1: ROM version 2.00 or higher
SY2: ROM version 2.00 or higher
SSX: ROM version 2.00 or higher
If the ROM version is lower than the value described
above, the version-up must be required. For the version-up,
contact your local Sony Sales Office/Service Center.
m
Turn off the power before starting the installation.
A rear shield lid is used in the DNW-A100P only.
(1) Remove the connector panel assembly. (Refer to "2-3-
3. Connector Panel Assembly Removal/Installation".)
(2) Peel off the shielding tape from the connector panel.
(3) Unscrew the screw (PSW 3 x 6) fixing the CP shield
plate (B) and rear shield lid.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
(4) Disconnect the flat harness (60-pin) from the connec-
tor (CN401) on the CP-297 board, and remove the CP
shield plate (B) and rear shield lid simultaneously.
n
For DNW-A100:
For DNW-A100P: The flat harness (60-pin) is pasted
1 pc
1 pc
1 pc
1 pc
2 pcs
Connector panel
assembly
This figure is the DNW-A100P.
(5) Pinch the claws of the hole plug using a long-nose
pliers as shown in the figure, then remove the plug
holder by pushing it from the inside of the connector
panel .
1-17. Installation of BKNW-103
The flat harness (60-pin) is pasted
on the CP shield plate (B).
on rear shield lid.
Flat harness
Screw(PSW3 x 6)
CP-297 board
Hole plug
Shielding tape
Rear shield lid
CP shield plate(B)
CN401
1-37