Board Replacement; Replacement Procedure - Sony Betacam SX DNW-A100 Maintenance Manual
Digital video hybrid recorder
Hide thumbs
Also See for Betacam SX DNW-A100:
- Maintenance manual (506 pages) ,
- Operation manual (134 pages) ,
- Brochure & specs (14 pages)
Table of Contents
Advertisement
6-5. EQ-56 Board Replacement
6-5. EQ-56 Board Replacement
The electrical adjustments are essential after the EQ-56 board is replaced.
To perform the electrical adjustments, the following equipment and fixtures are required.
. Oscilloscope:
. Composite video monitor (to display of the maintenance mode)
. Extension board:
. Alignment tapes
For DNW-A100/A50/A45:
For DNW-A100P/A50P/A45P:
. Recording tape:
n
Use the virgin tape or no recorded tape for recording tape that is used during the adjustment of the EQ-
56 board.
6-5-1. Replacement Procedure
n
Turn off the POWER switch before starting the replacement.
(1) Remove the upper lid, board retainer (S), and EQ-56 (original) board.
(Refer to "6-1-3. Plug-in Board Pulling out/Insertion".)
(2) Disconnect the harnesses to the EQ-56 (original) board, then connect them to the EQ-56 (new) board.
(3) Insert the EQ-56 (new) board.
(Refer to "6-1-3. Plug-in Board Pulling out/Insertion".)
(4) Extend the DM-89 board with the EX-377 extension board.
(5) Clean the video heads.
(Refer to "5-2-3. Tape Running Surface of Upper Drum and Video Heads Cleaning".)
(6) Set the CHARACTER switch on the sub control panel to ON.
(7) Perform the electrical adjustment (Section 6-5-2).
(8) Turn off the power, and wait for 30 seconds.
(9) Remove the adjusted DM-89 board from the extension board, then pull out the extension board.
(10) Insert the adjusted DM-89 board.
(11) Reattach the board retainer (S) and upper lid.
(Refer to "6-1-3. Plug-in Board Pulling out/Insertion".)
(12) Return the CHARACTER switch state to previous state.
6-74
TEKTRONIX 2465B or equivalent
EX-377 (SONY part No. J-6269-810-A) (for DM-89 board)
SR5-1
(SONY part No. 8-960-075-01),
CR5-1B (SONY part No. 8-960-096-41), and
CR5-2A (SONY part No. 8-960-097-44)
SR5-1P (SONY part No. 8-960-075-51)
CR5-1B PS (SONY part No. 8-960-096-91), and
CR5-2A PS (SONY part No. 8-960-098-44)
BCT-SX series (Betacam SX cassette: SONY standard products)
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Advertisement
Table of Contents
