1-1. Installation Procedure
c
This unit has build-in hard disk drives (HDDs). Pay careful
attention when installing the unit.
Be careful not to give a shock and mechanical vibration to
it. This may cause a trouble.
Installation procedure of this unit is shown on the follow-
ing flowchart.
Refer to each section about detail of each flow.
The operation manual is also required to do *-marked
flow.
Start
Determination of
installation place
Unpacking
n
When the unit is transported, it is required to pack the unit into the specified new packing materials.
Do not reuse the packing materials.
Rack mounting
*Connection
*Initial setup
*Operation check
n
If an error message is shown on the time data display area, refer to "3. Error Message".
Installation of
optional board
End
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
Section 1
Installation
1-3. Operating Conditions
1-4. Power Supply
1-5. Installation Space
1-6. Rack Mounting
1-7. Matching Connectors and Cables
1-8. Signal Inputs and Outputs
1-9. Switch Settings on Connector Panel
1-10. Switch and Short Plug Setting on PC Boards
1-11. Mode Switching of Search Dial
1-12. Setup Menu (ITEM F-Series)
1-13. Reference System
1-14. Switching between 525/625 Line Systems
1-15. Settings and Adjustment when Peripheral Equipment is Connected
1-16. Installation of BKDW-505/506
1-17. Installation of BKNW-103
1-18. Installation of BKNW-104
1-19. Installation of BKNW-105
1-2. Supplied Accessories
AC power cord set ............................................................. 1
Plug holder ......................................................................... 1
SCSI terminal connector .................................................... 1
Screws for rack mounting (PSW 4 x 16) .......................... 4
Operation manual .............................................................. 1
Maintenance manual (Part 1) ............................................. 1
1-1