Sony Betacam SX DNW-A100 Maintenance Manual page 125

Protecting operations: HDD Illegal Format(24):
After the following step automatically performs according to the occurring state
of abnormal Cautomatically enters D3 : INSTALLATION (hard disk installation
menu) of the maintenance mode.
. Copies the file system's data to the abnormal HDD from the normal HDD
when the abnormality was found in one of a pair.
. Perform the logical format for HDDs when the abnormalities were found in
both HDDs of a pair.
m
. When D3 : INSTALLATION (hard disk installation menu) of the maintenance
mode enters, be sure to perform the step according to instruction of its menu.
. Paired SCSI IDs: ID0 and ID1
Wrong Zone (27):
When the abnormality is found, a menu for changing the zone automatically
appears.
Except above sub error message:
Disables the access to the hard disk drive.
n
All operations can not be performed concerning the hard disk drives.
Supp. remarks
1. Generally, the sub error messages "HDD Not Supported(22)" and "HDD Unformatted(23)" are
not occurred. Those errors may occurs in case of that unspecified HDD as repair parts is installed.
In this case, require replacing to the specified HDD.
2. If the specified steps are not performed after replacing the HDD, the error code D2 by the sub error
message "HDD Illegal Format(24)" is displayed.
3. If the jumpers except SCSI ID are changed, the error code D2 by the sub error message "HDD
Incorrect Jumper(25)" may be displayed. Do not change carelessly the settings of the jumpers
except SCSI ID.
For the settings of internal HDD's jumpers, refer to the maintenance manual part 2, volume-1.
4. The sub error message "Wrong Zone (27)" appears when the BKNW-116 connected to this unit,
such as FULL zone, is disconnected and another BKNW-116, such as HALF-1 zone, is connected
instead.
5. In this unit, the zone size of BKNW-116 is examined when changing the zone from INTERNAL to
EXT.
# mark(s) indicating the zone size based on the examination result and a message "!!! ZONE MIS-
MATCH !!!" are displayed when the examination result does not coincides with the specified zone
size.
The zone size can be changed after the message "!!! ZONE MISMATCH !!!" is displayed.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
(HDDs of this unit)
ID2 and ID3
ID4 and ID5
(HDDs of the BKNW-116)
ID6 and ID7
ID8 and ID9
3-2. Details of Error Messages
3-23