Sony Betacam SX DNW-A100 Maintenance Manual page 184

4-2. TAPE Maintenance Mode (M0)
4-2-7. SERVO ADJUST Mode (A0)
A012 : NV-RAM CONTROL
The A012 : NV-RAM CONTROL menu is used to save
the servo adjustment data adjusted in the SERVO ADJUST
mode in the NV-RAM of a servo system.
c
Do not save the adjustment data in NV-RAM when
abnormality is found during automatic adjustment (when
"# ADJUST INCOMPLETE #" is displayed).
n
When adjustment data was not stored in this menu, it
returns to the state before adjustment if the power is turned
off.
To execute the data save
(1) Turn the search dial and move the * mark to "SAVE
SERVO ADJUST DATA" on the superimpose picture.
. In a time data display area, NO OPERATION is
displayed as "A0120", and SAVE SERVO ADJUST
DATA is displayed as "A0121".
(2) Press the SET button.
. The data transmission is initiated when the SET
button is pressed. The data transmission time is
about ten seconds.
. Message "SAVING....." is displayed on the superim-
pose picture, and "A0121 00" is displayed in the
time data display area.
(3) Confirm that the data transmission is completed.
. After the data transmission is completed, message
"DATA SAVED" is displayed on the superimpose
picture and "A0121 10" is displayed in the time data
display area.
(4) Press the MENU button to terminate the menu.
4-50
Example of display and operation
Superimpose picture
SERVO ADJUST
A012:NV-RAM CONTROL
*
NO OPERATION
SAVE SERVO ADJUST DAT
(1) 0 DIAL (2)
SERVO ADJUST
A012:NV-RAM CONTROL
NO OPERATION
*
SAVE SERVO ADJUST DATA
(2) 0 [SET]
SERVO ADJUST
A012:NV-RAM CONTROL
NO OPERATION
*
SAVE SERVO ADJUST DATA
SAVING.....
0
SERVO ADJUST
A012:NV-RAM CONTROL
NO OPERATION
*
SAVE SERVO ADJUST DATA
DATA SAVED
(3) 0
Confirm
[MENU]
(4) 0
Time data display area
A0120
A0121
A0121 00
A0121 10
DNW-A100/A50/A45
DNW-A100P/A50P/A45P