Sony Betacam SX DNW-A100 Maintenance Manual page 50

(6) Insert the BNC connector on the CP-300 board into the
hole of the connector panel, then loosely attach the
CP-300 board with the supplied screw (PSW 3 x 6).
(7) Loosely screw the left side of the BNC connector to
the connector panel with the supplied screw (BVTT 3
x 6) .
(8) Screw the right side of the BNC connector with the
supplied screw (BVTT 3 x 6) firmly.
(9) Fully tighten the screws that are loosely screwed in
steps (6) and (7).
Screw
(PSW3 x 6)
CP-300 board
BNC connector
(10)Connect the supplied power harness between CN404
on the CP-300 board and CN404 on the MB-648 board.
(11)Loosen the coating lead pin on the CP-297 board, and
loosen the harness.
(12)Fix the power harness that is connected in step (10)
and the harness that is loosened in step(11) using the
coating lead pins on the CP-297 board and CP-300
board.
Power harness
CN404
MB-648 board
Coating read pins
1-38
Screws(BVTT3 x 6)
CP-297 board
CP-300 board
CN404
(13)Place the CP shield plate (B) and rear shield lid so that
the claws of the shield plate (B) place the inside of the
connector panel, and connect the flat harness (60-pin).
n
Arrange the power harness in a space of the CP shield
plate (B) so as not to catch the harness.
(14)Attach the CP shield plate (B) and rear shield lid by
the screw (PSW 3 x 6) that is unscrewed in step (3).
(15)Stick the edge of the shielding tape covering the flat
harness (60-pin) that is peeled off in step (2) on the
connector panel.
(16)Connect the supplied flat cable (30-pin) between
CN403 on the CP-300 board and CN403 on the MB-
648 board .
Flat harness
Flat cable
CN403
Space
This figure is the DNW-A100P.
(17)Reinstall the connector panel assembly as not to catch
the harness. (Refer to "2-3-3. Connector Panel Assem-
bly Removal/Installation".)
(18)Perform "1-17-2. Check after Installing".
Screw(PSW3 x 6)
Shielding tape
Get into the
CN403 connector panel.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P