Downloading; Initialization; Configuration; Camera Control Configuration - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Central Devices
table 9.3: Audio output, connection
Pin Type
1 XLR
2
3
4 Cinch
5
You can select the procedure that is used to send audio
signals through the basic central control unit with the
available audio routing modes (refer to section 8.10.11).
table 9.4: Audio output details
Number of connections:
• 1x XLR plug (audio input 1 only)
• 1x double cinch socket
Location:
Rear side
Cable:
Shielded cable
Maximum level:
Refer to appendix A
Nominal level (audio output 1):
Refer to appendix A
Nominal level (audio output 2):
Refer to appendix A
Frequency response:
-3 dB @ 20 Hz and 20 kHz
Impedance:
< 100 Ω
Signal-to-noise ratio:
> 89 dBA @ max. level
Crosstalk attenuation
> 85 dB @ max. level
Distortion:
< 0.05% @ 1 kHz @ - 3 dB of the max. input
9.5.6 RS232 port
Refer to section 8.5.8 for information about the RS232
port of the basic central control unit. The RS232 ports
of the central control unit and the basic central control
unit are the same.
Bosch Security Systems | 2007-02 | 9922 141 70525
Signal Description
Xternal Shield/ground
Live Positive
Return Negative
Live Signal out
Return Shield/Ground
9.6

Downloading

This information is the same for the basic central control
unit and the CCU (refer to section 8.6).
9.7

Initialization

This information is the same for the basic central control
unit and the CCU (refer to section 8.7).
9.8

Configuration

This information is the same for the basic central control
unit and the CCU (refer to section 8.8).
9.9

Camera control configuration

9.9.1 Introduction
The basic central control unit can automatically point
video cameras in the direction of the delegate or
chairman that speaks.
You can connect camera(s) as follows:
• Direct camera control in a system without a PC
• Camera control through a video switcher in a system
without a PC
9.9.2 Direct camera control without a
PC
This information is the same for the basic central control
unit and the CCU (refer to section 8.9.2), except that the
baud rate and protocol settings apply to the RS232 port
1.
9.9.3 Video switcher without a PC
This information is the same for the basic central control
unit and the CCU (refer to section 8.9.3), except that the
baud rate and protocol settings apply to the RS232 port
1.
9. 1 0

Configuration menu

This information is the same for the basic central control
unit and the CCU (refer to section 8.10), except that the
options under sub-menu 7I (Multi mode) are not
available.
en | 75