Cnconfig - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Central Devices
13.7

CNConfig

13.7.1 Introduction
With the CNConfig, you can change the values of
CobraNet parameters of CobraNet devices with a PC.
Note
We assume that you understand the basic
theory of CobraNet networks.
13.7.2 Installation
Install the CNConfig in a PC with the CD-ROM that is
supplied with your system. The CD-ROM contains an
automatic set-up program.
13.7.3 Start
Make sure that the PC in which you installed the
CNConfig is connected to the CobraNet network.
On the PC, go to Start > Programs > Bosch >
CNConfig. The monitor of the PC shows the CobraNet
Settings window (refer to figure 13.9 for an example).
13.7.4 Operation
13.7.4. 1 Introduction
The CobraNet Settings window (refer to figure 13.9)
shows the CobraNet devices on the CobraNet network
and their CobraNet parameters.
figure 13.9: CobraNet Settings window
Bosch Security Systems | 2007-02 | 9922 141 70525
To decrease the width of a column:
1 Click-and-hold the left mouse button on the right
boundary of the column.
2 Move the mouse to the left to decrease the width of
the column.
3 Release the left mouse button.
To increase the width of a column:
1 Click-and-hold the left mouse button on the right
boundary of the column.
2 Move the mouse to the right to increase the width of
the column.
3 Release the left mouse button.
To change the value of one parameter of a device:
1 Click on the device with the left mouse button.
2 Click on the parameter with the right mouse button.
3 Change the value of the parameter.
Note
To change the values of more than one
parameter at the same time, use the Advanced
configuration window (refer to figure 13. 1 0).
To open the on-line help:
• Push the F1 function button on the keyboard of the
PC in which the CNConfig was installed.
• Go to X:\Program Files\Bosch\CNConfig and
double-click with the left mouse button on
CNConfig.chm. (X is the letter of the harddisk.)
13.7.5 Configuration
13.7.5. 1 Introduction
With the Advanced Configuration window (refer to
figure 13.10), you can change the values of the
CobraNet parameters of the CobraNet devices. To open
the Advanced Configuration window, double-click on
the CobraNet device in the CobraNet Settings window
(refer to figure 13.9).
Note
Do not use the Advanced configuration window
to give IP addresses to CobraNet devices.
Always use CobraNet Discovery to give IP
addresses to CobraNet devices.
en | 131