Bosch DCN Next Generation Installation & User's Instructions page 214

DCN Next Generation | Installation and User Instructions | Interpretation Devices
33.6.4 Navigation in the installation
mode
In the installation mode, only a small number of
controls are available (refer to table 33.11 and figure
33.1).
table 33. 1 1: Controls in the installation mode
Control
Primary knob
Preselect channel
button a
Preselect channel
button b
Preselect channel
button d
Preselect channel
button e
Output selection
button B
33.6.5 Configuration procedures
To select the necessary parameters in the installation
menus to configure the interpreter desk do as follows:
1 Push the a and b preselect channel buttons to go to
the necessary installation menu. The parameter that
is set has square brackets, for example, [option].
2 Push the d preselect channel button to clear the set
parameter. The square brackets change to arrow
brackets, for example, <option>. This shows that
you can select a different choice with the primary
knob.
3 Turn the primary knob to go to the necessary
parameter. When the correct parameter is selected,
push the e preselect channel button. The arrow
brackets change to square brackets.
Bosch Security Systems | 2007-02 | 9922 141 70525
Function
Select menu option(s)
Go to the previous menu
Go to the next menu
Clear current selection
Enter current selection
Exit the installation mode
33.6.6 Menu screens
33.6.6. 1 Menu a
Menu a sets the display language of the interpreter desk
when in the installation mode. The language is set for all
interpreter desks in the system.
33.6.6.2 Menu b
Menu b sets the interpreter desk to an interpreter booth.
It is necessary to set each interpreter desk in turn.
Note
If an interpreter booth is full, no entry is possible
and no response is given.
33.6.6.3 Menu c
Menu c sets a desk number to the unit in the interpreter
booth. It is necessary to set each interpreter desk in turn.
Note
If a desk number is already in use, no entry is
possible and no response is given.
en | 214