Installation - Bosch DCN Next Generation Installation & User's Instructions

DCN Next Generation | Installation and User Instructions | Contribution Devices
14.4.4 Dual delegate
When the discussion unit is in the dual delegate mode, it
is a delegate device for 2 delegates. The system sees the
discussion unit as two separate devices, but it gives only
one address to the discussion unit. You can only put
these types of discussion units in the dual delegate
mode:
• DCN-DISD
• DCN-DISDCS
When you put the discussion unit in the dual delegate
mode, you must also install the DCN-DISBDD Buttons
(refer to figure 14.8 and section 14.5.2).
figure 14.8: DCN-DISBDD Buttons
Note
The DCN-DISBDD buttons come with a tool
that you can use to remove the old buttons from
the discussion unit (refer to figure 14. 1 1).
14.4.5 Single delegate with auxiliary
control
When the discussion unit is in the single delegate with
auxiliary control mode, it is a delegate device for 1
delegate. The delegate can use the left microphone
button as an auxiliary button. For example, to activate
an indicator.
Note
When the delegate pushes the auxiliary button,
the auxiliary button makes an event. Use the
Open Interface to program the actions that must
be started by the event. Refer to the applicable
Software User Manual for instructions that tell
you how to program the Open Interface.
Bosch Security Systems | 2007-02 | 9922 141 70525
You can only put these types of discussion units in the
single delegate with auxiliary control mode:
• DCN-DISD
• DCN-DISDCS
• DCN-DISV
• DCN-DISVCS
When you put the discussion unit in the single delegate
with auxiliary control mode, you must also install two
microphone buttons (refer to section 14.5.2). For
example, you can use the DCN-DISBCM Buttons (refer
to figure 14.7).
14.5

Installation

14.5.1 Rims
The discussion units are delivered without rims. Before
you install the discussion unit, you must first attach a
DCN-DISR Rim to it. With the rims, you can change
the look of the discussion unit.
Refer to figure 14.9 for instructions that tell you how to
attach a rim to a discussion unit. Refer to figure 14.10
for instructions that tell you how to detach a rim from a
discussion unit.
figure 14.9: Attach a rim
en | 143