Change Drive Object Number / Change Drv_Obj_No; Change Component Number / Change Comp_No - Siemens SINAMICS G150 Manual

p9913[0...2]

Change drive object number / Change drv_obj_no

CU_G130_DP, Can be changed: C1(4)
CU_G130_PN,
Data type: Unsigned16
CU_G150_DP,
P-Group: -
CU_G150_PN
Not for motor type: -
Min
0
Description: Existing drive objects can be assigned new numbers using these parameters.
Index 0:
The values 2 ... 62 are permissible.
Index 1:
The values 2 ... 62 are permissible.
Index 2:
= 0: Ready.
= 1: Reset (only indices 0 ... 2).
= 2: Reset all (indices 0 ... 2 and flagged entries).
= 3: Check and flag for modification.
Index: [0] = Drive object number old
[1] = Drive object number new
[2] = Reset or check and flag for modification
Note: Only for internal Siemens use.
The parameter is not displayed for the STARTER commissioning software.
p9914[0...2]

Change component number / Change comp_no

CU_G130_DP, Can be changed: C1
CU_G130_PN,
Data type: Unsigned16
CU_G150_DP,
P-Group: -
CU_G150_PN
Not for motor type: -
Min
0
Description: You can change the number of topology components using this parameter.
Index 0:
The values 2 ... 199 are permissible.
Index 1:
The values 2 ... 199 are permissible.
Index 2:
= 0: Ready.
= 1: Reset (only indices 0 ... 2).
= 2: Reset all (indices 0 ... 2 and flagged entries).
= 3: Check and flag for modification.
Index: [0] = Component number old
[1] = Component number new
[2] = Reset or check and flag for modification
Note: Only for internal Siemens use.
The parameter is not displayed for the STARTER commissioning software.
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
62
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
199
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 0
Factory setting
0
953