Parameters With "Khp_Write_No_Lock" - Siemens SINAMICS G150 Manual

2.4.2

Parameters with "KHP_WRITE_NO_LOCK"

The following list contains the parameters with the "KHP_WRITE_NO_LOCK" attribute.
These parameters are not affected by the know-how protection.
Product: SINAMICS G130/G150, Version: 4702900, Language: eng, Type: KHP_WRITE_NO_LOCK
p0003
p0009
p0124[0...n]
p0124[0...n]
p0144[0...n]
p0154
p0154
p0972
p0976
p0977
p2035
p2040
p2102
p2111
p3100
p3101[0...1]
p3103
p3950
p3981
p3985
p7761
p7770
p8550
p8805
p8806[0...53]
p8807[0...15]
p8808[0...53]
p8809[0...53]
p8829
p8835
p8839[0...1]
p8840
p9210
p9211
p9484
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
2.4 Parameters for write protection and know-how protection
BOP access level / BOP acc_level
Device commissioning parameter filter / Dev comm par_filt
Power unit detection via LED / PU detection LED
Main component detection using LED / M_comp detect LED
Sensor Module detection via LED / SM detection LED
DRIVE-CLiQ Hub Module detection via LED / Hub detection LED
Terminal Module detection via LED / TM detection LED
Drive unit reset / Drv_unit reset
Reset and load all parameters / Reset load all par
Save all parameters / Save all par
Fieldbus interface USS PIV drive object number / Fieldbus USS DO_no
Fieldbus interface monitoring time / Fieldbus t_monit
BI: Acknowledge all faults / Ackn all faults
Alarm counter / Alarm counter
RTC time stamp mode / RTC t_stamp mode
RTC set UTC time / RTC set UTC
RTC synchronization source / RTC sync_source
Service parameter / Serv par
Faults acknowledge drive object / Faults ackn DO
Master control mode selection / PcCtrl mode select
Write protection / Write protection
NVRAM action / NVRAM action
AOP LOCAL/REMOTE / AOP LOCAL/REMOTE
Identification and maintenance 4 configuration / I&M 4 config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
Identification and Maintenance 3 / I&M 3
Identification and Maintenance 4 / I&M 4
CBE2x remote controller number / CBE2x rem ctrl num
CBE20 firmware selection / CBE20 FW sel
PZD interface hardware assignment / PZD IF HW assign
COMM BOARD monitoring time / CB t_monit
Flashing component number / Flash comp_no
Flash function / Flash fct.
BICO interconnections search signal source / BICO S_src srch
2 Parameters
1021