Samsung DCS Technical Manual page 55

SAMSUNG DCS
TECHNICAL MANUAL
MMC 212:
DESCRIPTION:
Used to determine which devices will be alerted when an alarm sensor is activated. The alerted device can
be as follows:
Station 201-3XX
Station group 500-529
The above devices will ring like a door phone and follow the door ring time-out. When ringing, display keysets
will show the display assigned in MMC 213 Alarm Message. The bottom line of the keyset display will give an
option to clear the alarm. Ringing initiated by an alarm sensor is answered by going off-hook and on-hook
again at a ringing keyset. If a device such as Ring Over Page or a common bell is the only device assigned to
ring, it may be answered by assigning a direct pickup key with this device as the extender. If the alarm is
unanswered by the door ring time-out, ringing will cease but the display will remain until cleared by dialling the
alarm clear feature code (57) and passcode (default 8765).
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
ACTION
1 Press TRSF 212
Display shows first sensor
2. Dial sensor number (eg., 3502 )
Use UP or DOWN to scroll through sensor
numbers and press RIGHT soft key to
advance cursor
3. Enter valid ring destination (eg., 205)
Press UP or DOWN key to make selection
and press RIGHT soft key to advance cursor
to night destination and press RIGHT soft
key
4. Press TRSF to store and exit
Press SPK to store and advance to next
MMC
DEFAULT DATA:
RELATED ITEMS:
Note: This MMC is not applicable to DCS Compact System or the DCS24 / DX408 Systems
Page 55 of 280 DCS & DX I&M
500-519
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
OR
OR
OR
ALL SENSORS RING 500 DAY/NIGHT
MMC 213 ALARM MESSAGE
Alarm Ringing Station
DISPLAY
[3501] ALARM RING
D : 500
[3502] ALARM RING
D : 500
[3502] ALARM RING
D : 205
PROGRAMMING
SECTION
N : 500
N : 500
N : 500
August 2001