P-Opt (Cleaning Mode) - Canon 1000 Service Manual

2. P-OPT (cleaning mode)

DISP COUNTER
ADJUST
FUNC
OPTION
TEST
Item
T-WEB
(Note 1)
TBLT-POS
(Note 1)
F-WEB-MD
F-WEB
(Note 1)
CONT-SET
(Note 1)
REG-NEXT
Note 1:
The value will return to the standard value when the RAM is initialized, requiring re-input. Be sure to
record any new value on the service label.
COPYRIGHT © 2001 CANON INC.
<M> <S>
P-OPT
T-WEB
TBLT-POS
0
F-WEB-MD F-WEB
0
CONT-SET REG-NEXT
0
Description
Changes the frequency at which the transfer belt
cleaning web turns on.
Changes the stop position of the transfer belt.
Changes the ON/OFF sequence of the web
solenoid when the fixing web solenoid is turned on.
At present, the setting is always '1'.
Changes the frequency at which the fixing web
solenoid turns on.
Use it to set the copy count at which copy count
should start.
For instance, if set to '100', the counter 3 will
start to count in response to a press on the Start
key as long as the copy count is set to '100' or
lower.
Use it to delay the timing at which the sheet of
paper is picked up to prevent lines in main
scanning direction near 188mm from leading
edge of paper.
0:normal operation
1:delay pickup timing
The potential on the transfer belt is
not staple when the first copy is
REF.
made, with the photosensitive drum at
times developing paper traces (drum
memory) caused by the leading edge
of paper. The traces will collect toner,
and a line will occur on the next copy
near 188mm from its leading edge.
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
<R> <P>
READY
0
0
0
<F>
READY
Remarks
Settings: 1~5
Standard: 3
Settings: –2~2
Unit = 2 mm
Standard: 0
Standard: 1
Settings: 1~255
Standard: 8
Settings: 0~999
Standard: 100
The setting is effective
only if
DISPLAY>VERSION>CNT-
MODE=7 (111).
Standard:0
7-289