Shifting The Scanner Unit - Canon 1000 Service Manual

4. MECHANICAL SYSTEM
• Points to Note When Installing the Tilt
Correcting Motor
1) Install the motor [3] with a screw [2] while
moving the mirror assembly [1] in the direction
of the arrow.
At this time, force the motor in the direction in
which the screw is tightened.
2) Fit the screw [4].
[3]
[2]
[4]
Figure 4-608B

4. Shifting the Scanner Unit

1) Remove the scanner retainer right, upper rear
right cover, and digital covers 1, 2, 3, and 4.
2) Keep the digital unit where it should be fixed in
place (See chapter 4. VI. LASER SYSTEM, A-
1. Making Preparation for Laser Unit-Related
Parts).
3) Disconnect the two connectors [1] on the
analog processor PCB, and remove the two
screws [2]; then, remove the analog processor
PCB [3].
[3]
Figure 4-609B
4-66
COPYRIGHT © 2001 CANON INC.
[1]
[1]
[2]
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4) Fix the analog processor PCB on the hooking
hole [4] with a screw [5].
[4]
[5]
Figure 4-610B
5) Remove the three screws [6], and remove the
duct plate [7].
[6]
Figure 4-611B
[6]
[7]