Checking Images And Operations - Canon 1000 Service Manual

I.

Checking Images and Operations

Step
1 Remove the cover switch actuator, and
close the front covers.
2 Set the cassette size to suit the needs
of the user.
• First, set the side guide plate to suit
the paper size. Then, put paper in the
cassette, and adjust the trailing edge
guide plate against the trailing edge of
the paper.
3 Remove the cassette size plate from
each cassette, and attach the
appropriate size label.
4 Install the cassettes back into their
original positions.
5 Set the CA-1 Test Chart on the
copyboard, and make a copy to check
the image.
6 If you have made adjustments, select
'ADJSUT > PASCAL' in service mode,
and check that 'PASCAL' is set to '1'.
Otherwise, set it to '1'.
7 Press the Reset key to end service
mode.
8 Execute auto gradation correction in
user mode.
9 Check the external covers for damage
and deformation.
10 Clean up the area around the machine.
11 Fill out the service sheet.
COPYRIGHT © 2001 CANON INC.
Work
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Check to make sure that the 'Add Paper' indicator
turns off.
Press a key on the control panel (other than the Start
key) to make sure that operation is normal.
• Make sure there is no abnormal noise.
• Check the copy image for each default ratio.
• Make sure that the specified number of copies are
made normally.
• Try each cassette, paper deck, and multifeeder.
• If the image is not normal, make adjustments
according to the 'Basic Image Adjustment
Procedure.'
5. INSTALLATION
Remarks
5-35