Powering On The Handset - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
11.5
System Hardware Manual
2. Use the charger AC adapter to connect the charger's AC jack to a
standard electrical outlet.
3. Place the handset in th echarger with the display facing forward. the
HANDSET STATUS LED should turn on; if it doesn't, reseat the handset
or try plugging the AC adapter into a different outlet.
4. Place the spare battery (if available) in the back section of the charger;
the BATTERY STATUS LED should turn on. (Pull the battery latch back
slightly to fit the battery in the slot.)
Figure 5-177 ML440 - Insert Handset into Charger
Charge each battery approximately 10 hours before use.
.

Powering on the Handset

To power up the handset, press and hold End until the display flashes once
(about three seconds). The handset searches for the base station or multi-cell
chain it is registered to and connects to the unit with the strongest signal.
Issue 1.2
5 - 151