Connecting The Dt700/Dt800 Series Ip Multiline Terminal To The Network And Pc; Section 3 Dt700/Dt800 Series Ip Multiline Terminals - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4.3
5 - 48
Connecting the DT700/DT800 Series IP Multiline Terminal to the
Network and PC
These instructions for connecting an IP Multiline Terminal to the Network and
PC apply to DT700/DT800 series Multiline Terminals. Refer to
Terminal Connector Locations.
1. Connect the LAN Network
connector.
2. The IP terminal has a switching HUB to connect a PC to the LAN
Network. Connect the 10 Base-T/100 Base-TX straight cable used for
this connection to the PC(x) connector and to the PC.
Refer to Figure 5-38 Typical Network IP Connection on page
LAN (=) PC(x)
Connections
Figure 5-37 IP Terminal Connector Locations
10Base-T/100Base-TX
Installing DT Series Digital and IP Multiline Terminals
UNIVERGE SV9100
Figure 5-37 IP
cable to the LAN (=)
5-49.