NEC Univerge SV9100 Hardware Manual page 407

UNIVERGE SV9100
Top LED, Yellow
System Hardware Manual
2. Route the cable through the channel.
Figure 5-172 Install AP300 Base Station
3. Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the
front briefly lights yellow and then turns off while it initializes
and connects to the network. After the base station
successfully initializes and connects to the network, the Yellow
LED light remains steady on (refer to
LED States and Meanings on page
Table 5-19 Base Station LED States and Meanings
LED Status
Off
0.5 seconds on - 0.5
seconds off
Short flash every
0.25 seconds
Fast Blink
Continuous Fast
Blink
Steady On
State
No Power
Loading software/firmware
IP Network error (not connected, no DHCP/
TFTP server, no DAP Controller
DAP Operational but trying to synchronise to
another DAP
Hardware Error
DAP Operational (and synchronised to other
DAP or is the synchronisation master)
Issue 1.2
Table 5-19 Base Station
5-147).
Meaning
5 - 147