Table 8: Connection To Northstar 800 Port A; Table 9: Connection To Northstar 800 Port B; Table 10: Northstar 800 Series Output Port Setup - NorthStar 951X Installation Manual

SECTION THREE - Interfacing
Page 54
Downloaded from www.Manualslib.com
data output to be received by the unit. Port 1 or Port 2 of the unit, or A or
B of the 800, may be used. Wire colors refer to the unit's interface cable.

Table 8: Connection to Northstar 800 port A

800 OUTPUT
Port A
Pin 12
Pin N

Table 9: Connection to Northstar 800 port B

800 OUTPUT
Port B
Pin 7
Pin H
To configure the Northstar 800 for correct output format, execute COM-
MAND 83 for output port A, or COMMAND 84 for output port B. Press the
lower SELECT button until PRINTER 3 appears in the lower display, and
press ENT. Then enter the following sequence to program the output
parameters:

Table 10: Northstar 800 series output port setup

At this prompt
SET UP
INTERVAL
ITEM 1
ITEM 2
ITEM 3
ITEM 4
ITEM 5
* Only used if you want the waypoint to which you're navigating to be
automatically transferred to the unit's waypoint database.
For further details, you may want to refer to the Northstar 800/800X Ref-
erence Manual (Part Number GM260).
manuals search engine
CONNECT TO EITHER
951/952 Port 1
brown (#3)
blue (#1)
CONNECT TO EITHER
951/952 Port 1
brown (#3)
blue (#1)
Press To output this data to the 951/952
149 (ENT) 0183 output format
1 (ENT) 1 second output rate
13 (ENT) include GTD sentence in output
26 (ENT) waypoint location*
31 (ENT) include SRS sentence in output
40 (ENT) include RMA sentence in output
0 (ENT) end of sequence
951/952 INSTALLATION MANUAL Revision B
951/952 Port 2
white with brown stripe (#6)
brown with white stripe (#2)
951/952 Port 2
white with brown stripe (#6)
brown with white stripe (#2)
(8 bits, no parity, 4800 baud)
(Loran-C TDs)
(status of received signals)