NorthStar 951X Installation Manual page 60

SECTION THREE - Interfacing
Page 50
Downloaded from www.Manualslib.com
•
connector backshell
•
rubber-strain relief boot that fits inside the backshell
• twist lock (also known as a quarter turn), ensuring that it's facing in
the correct direction.
3. Trim and prepare the wires for soldering to the connector body.
4. Install the ferrite beads on the appropriate wires.
5. Terminate the cable, as described below.
To terminate the cable:
1. Terminate and solder the appropriate wires to the appropriate pins.
See Figure 22: "Aux port interface diagram (wiring side view, solder
cup)," below.
manuals search engine
951/952 INSTALLATION MANUAL Revision B