Jacking Instructions - Toro Groundsmaster 360 Service Manual

Jacking Instructions

CAUTION
When changing attachments, tires or performing
other service, use correct supports, hoists and
jacks. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands or other appropriate load holding de-
vices to support the raised machine. If the ma-
chine is not properly supported, the machine
may move or fall, which may result in personal
injury.
Front End Jacking (Fig. 1)
1. Apply parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely under the front axle pivot. Do
not use the cutting deck or implement as a jacking point.
3. Use jack to raise front of machine.
IMPORTANT: Do not support machine on front
steering fork or front wheel motors (4WD ma-
chines).
4. After raising the front of the machine, use appropri-
ate jack stands under the frame to support the front of
the machine.
Rear End Jacking (Fig. 2)
1. Chock both front wheels to prevent the machine from
moving.
2. Place jack securely under the rear frame.
3. Jack rear wheels off the ground.
IMPORTANT: Do not support machine on rear wheel
hubs or wheel motors.
4. Use appropriate jack stands under the frame to sup-
port the rear of the machine.
Groundsmaster 360
2
1. Front axle pivot
2
1. Rear frame jacking point
Page 1 - - 5
1
2
Figure 1
2. Front tire
1
Figure 2
2. Rear tire
Safety
2