Transmission; Transmission Removal - Toro Groundsmaster 360 Service Manual

Transmission

RIGHT
FRONT
10
13
12
10
1. Transmission assembly
2. Dowel pin (2 used)
3. Cap screw (50 mm long) (6 used)
4. Cap screw (35 mm long)
5. Lock washer (7 used)
6. Bracket
7. Engine
Transmission Removal (Fig. 59)
WARNING
Before disconnecting or performing any work on
the hydraulic system, all pressure in the system
must be relieved. See Relieving Hydraulic System
Pressure in the General Information section.
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
Hydraulic System
400 in- -lb
(45 N- -m)
5
3
5
4
14
17
16
18
19
9
15
11
12
8. Flywheel housing
9. Cap screw (2 used)
10. Cap screw (4 used)
11. Shield
12. Lock nut (4 used)
13. Driveshaft assembly
Antiseize
Lubricant
6
1
Figure 59
2. Remove seat and seat plate from machine (see Op-
erator Seat Removal in the Service and Repairs section
of Chapter 6 -- Chassis).
3. To allow easier access to transmission area, remove
storage compartment from behind operator seat (see
Storage Compartment Removal in the Service and Re-
pairs section of Chapter 6 -- Chassis or, if machine is
equipped with operator cab, see Storage Compartment
Removal in the Service and Repairs section of Chapter
8 -- Operator Cab).
Page 4 - - 74
7
8
2
14. O- -ring
15. Roll pin (2 used)
16. Coupler
17. Gear pump assembly
18. Lock washer (2 used)
19. Cap screw (2 used)
Groundsmaster 360