Toro Groundsmaster 360 Service Manual page 152

10.Lubricate steering cylinder ball joint grease fittings.
11. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
12.Check that steering cylinder does not contact the
axle or frame as cylinder moves from fully retracted to
fully extended. Also, check that distance between the
drag links and steering stops are equal on both sides of
the machine. If necessary, adjust location of rod end on
cylinder shaft.
Hydraulic System
13.If removed, secure front cover to front axle (Fig. 133).
14.If removed, secure storage compartment to machine
(see Storage Compartment Installation in the Service
and Repairs section of Chapter 6 -- Chassis or, if ma-
chine is equipped with operator cab, see Storage
Compartment Installation in the Service and Repairs
section of Chapter 8 -- Operator Cab).
Page 4 - - 118 Groundsmaster 360