Toro Groundsmaster 360 Service Manual page 283

Removal (Fig. 52)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Unlatch and raise operator seat.
WARNING
If seat switch service is necessary, remove seat
from seat plate to access switch. To prevent inju-
ry, DO NOT attempt to reach switch through
openings in seat plate.
3. Disconnect machine wire harness electrical connec-
tor from the seat wire harness connector (Fig. 53). Note
routing of seat wire harness for assembly purposes.
4. Support seat and upper seat plate (item 20) to pre-
vent them from shifting during seat removal.
5. Remove four (4) carriage screws (item 14) and
flange nuts (item 12) that secure seat and upper seat
plate assembly to seat plate (item 17). Remove seat and
upper seat plate assembly from machine.
6. Remove seat parts and seat plate (item 17) as nec-
essary using Figure 52 as a guide.
Installation (Fig. 52)
1. Install all removed seat parts using Figure 52 as a
guide.
A. If seatbelt (item 6) or seatbelt latch (item 2) were
removed from seat assembly, apply Permatex Blue
Gel Threadlocker (or equivalent) to threads of cap
screw (item 5) before installing screw.
2. If seat plate (item 17) was removed, secure seat
plate to machine using Figure 52 as a guide.
3. Position seat and upper seat plate assembly to seat
plate. Secure assembly with four (4) carriage screws
(item 14) and flange nuts (item 12).
4. Connect wire harness electrical connector to the
seat switch harness (Fig. 53).
5. Lower and latch seat.
6. Check operation of operator seat switch.
Groundsmaster 360
3
1
1. Seat wire harness
2. Seat harness connector
Page 6 - - 49
1
3
2
2
Figure 53
3. Seat latch
Chassis