Toro Groundsmaster 360 Service Manual page 127

13.If shafts were disassembled, install gear and two (2)
bearings onto input shaft, RH pump shaft and/or LH
pump shaft. Make sure that bearings are pressed fully
to the shaft shoulder.
14.Lubricate seal rings and install seal ring onto RH and
LH pump shafts.
15.Install RH and LH pump shaft assemblies into trans-
mission pump housing. Then, install input shaft into
pump housing making sure to align input shaft gear
teeth with gears on PTO and pump shafts.
16.Lubricate two (2) new O--rings and install O--rings
into grooves in pipe. Slide pipe assembly into bore of
transmission pump housing.
Groundsmaster 360
1. RH pump shaft
2. LH pump shaft
3
4
1. Input shaft
2. RH pump shaft
Page 4 - - 93
1
3
2
Figure 100
3. Input shaft
4. Seal ring
1
2
Figure 101
3. LH pump shaft
4. Pipe assembly
Hydraulic System
4
4