Toro Groundsmaster 360 Service Manual page 110

12.Move transmission assembly toward the front of the
machine and away from the flywheel housing and cou-
pler on engine flywheel. Lift transmission from machine.
13.Locate and note location of two (2) dowel pins from
transmission and flywheel housing.
14.On both sides of transmission, remove retaining ring
that secures pump control arm onto transmission con-
trol arm (Fig. 60). Slide control arm from transmission
control arm.
58 to 72 ft- -lb
(79 to 97 N- -m)
RIGHT
FRONT
9 to 11 ft- -lb
(13 to 15 N- -m)
35 to 43 ft- -lb
(48 to 58 N- -m)
20 to 26 ft- -lb
(28 to 35 N- -m)
1. Transmission assembly
o
2. 90 hydraulic fitting
3. O- -ring
4. Gear pump assembly
5. Hydraulic fitting
6. Hydraulic fitting
o
7. 90 hydraulic fitting
8. O- -ring
9. O- -ring
Hydraulic System
60 to 74 ft- -lb
(82 to 100 N- -m)
60 to 74 ft- -lb
(82 to 100 N- -m)
2
19
17
18
21
5
20
9
23
15
15
7
20
o
10. 90 hydraulic fitting
11. Elbow fitting
o
12. 90 hydraulic fitting
13. Hydraulic fitting (4 used)
14. Hydraulic fitting
15. O- -ring
16. O- -ring
17. Dust cap
18. Test fitting
15.If hydraulic fittings are to be removed from transmis-
sion, mark fitting orientation to allow correct assembly.
Remove hydraulic fittings from transmission as needed.
Discard fitting O--rings.
16.Inspect flywheel housing and coupler on engine fly-
wheel for evidence of wear or damage.
17.Remove gear pump from transmission (see Gear
Pump Removal in this section).
18.Remove oil filter from transmission. Discard filter.
10
22
13
9
25
6
3
16
8 26
16
4
Figure 62
Page 4 - - 76
81 to 99 ft- -lb
(110 to 134 N- -m)
21
3
12
(48 to 58 N- -m)
24
11
3
14
16
16
2
19
1
19. O- -ring
20. O- -ring
21. O- -ring
22. O- -ring
23. Tee hydraulic fitting
24. O- -ring
25. O- -ring
o
26. 45 hydraulic fitting
Groundsmaster 360
35 to 43 ft- -lb
9 to 11 ft- -lb
(13 to 15 N- -m)