Toro Groundsmaster 360 Service Manual page 321

Disassembly (Fig. 9)
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake and remove key
from the ignition switch.
2. If access to wiper motor is necessary, remove fasten-
ers that secure roof in place. Raise and support roof to
allow access to condenser assembly (see Roof Assem-
bly Removal in this section).
3. Remove windshield wiper components as needed
using Figure 9 as a guide.
Groundsmaster 360
Assembly (Fig. 9)
1. Assemble windshield wiper components using Fig-
ure 9 as a guide.
2. If roof was raised, lower and secure roof assembly
(see Roof Assembly Installation in this section).
Page 8 - - 13 Operator Cab