Toro Groundsmaster 360 Service Manual page 121

39.Disassemble PTO shaft assembly:
A. Using a bearing puller, remove bearing from PTO
shaft. Discard bearing.
B. Remove spacer from PTO shaft.
C. Slide gear and clutch assembly from PTO shaft.
D. Remove key from PTO shaft slot.
E. Remove two (2) seal rings from PTO shaft
grooves. Discard seal rings.
F. Remove B--plate, C--plate, three (3) A--plates and
three (3) friction plates from PTO shaft.
G. Using a bearing puller, remove bearing from PTO
shaft. Discard bearing.
40.Slide three (3) rods from holes in clutch assembly.
41.Slide PTO gear assembly from clutch assembly.
NOTE: Because individual clutch components are not
available, disassembly of the clutch assembly is not
necessary.
Groundsmaster 360
2
1. Bearing
2. PTO shaft
3. Spacer
7
2
1. Seal ring (2 used)
2. PTO shaft
3. B- -plate
4. C- -plate
2
1. Rod (3 used)
2. Clutch assembly
Page 4 - - 87
5
6
4
Figure 84
4. Gear
5. Clutch assembly
6. Key
5
5 5
1
6
6
Figure 85
5. A- -plate (3 used)
6. Friction plate (3 used)
7. Bearing
3
1
Figure 86
3. PTO gear
Hydraulic System
1
3
4
6
3