Toro Groundsmaster 360 Service Manual page 119

33.Remove input shaft, RH pump shaft and LH pump
shaft assemblies from transmission pump housing.
34.Slide pipe assembly from bore of pump housing. Re-
move and discard two (2) O--rings from grooves in pipe.
35.If pump shaft bearing replacement is necessary, re-
move and discard seal ring from RH and LH pump
shafts. Remove bearings from pump shaft using a bear-
ing puller. Discard removed bearings. Remove gear
from pump shaft.
36.If input shaft bearing replacement is necessary, re-
move bearings from input shaft using a bearing puller.
Discard removed bearings. Remove gear from input
shaft.
Groundsmaster 360
3
4
1. Input shaft
2. RH pump shaft
1. RH pump shaft
2. LH pump shaft
Page 4 - - 85
1
2
Figure 80
3. LH pump shaft
4. Pipe
1
3
2
Figure 81
3. Input shaft
4. Seal ring
Hydraulic System
4
4