Hydraulic Test Fitting Kit - Toro Groundsmaster 360 Service Manual

High Flow Hydraulic Filter Kit
The high flow hydraulic filter kit is designed with large
flow (40 GPM/150 LPM) and high pressure (5000
PSI/345 bar) capabilities. This kit provides for bi--direc-
tional filtration which prevents filtered debris from being
allowed back into the circuit regardless of flow direction.
If a component failure occurs in the closed loop traction
circuit, contamination from the failed part will remain in
the circuit until removed. When connecting hydraulic
test gauges in order to test traction circuit components
or after replacing a failed traction circuit component (e.g.
hydrostat or wheel motor), the high flow hydraulic filter
can be installed in the traction circuit. The filter will en-
sure that contaminates are removed from the closed
loop and thus, do not cause additional component dam-
age.
Toro Part Number: TOR6011
NOTE: This kit does not include hydraulic hoses (see
Hydraulic Hose Kit TOR6007 above).
NOTE: Replacement filter element is Toro part number
TOR6012. Filter element cannister tightening torque is
25 ft- -lb (34 N- -m).

Hydraulic Test Fitting Kit

This kit includes a variety of O--ring face seal fittings to
enable the connection of test gauges into the system.
The kit includes: tee's, unions, reducers, plugs, caps
and male test fittings.
Toro Part Number: TOR4079
Wheel Hub Puller
The wheel hub puller allows safe removal of the wheel
hub from the wheel motor shaft.
Toro Part Number: TOR6004
Hydraulic System
TORO TEST FITTING KIT (TOR4079)
Page 4 - - 26
Figure 23
Figure 24
Figure 25
Groundsmaster 360