Rack Latches Replacement; Remove The Rack Latches - Lenovo ThinkSystem SR630 Maintenance Manual

a. Align the triangular mark on the heat sink label with the triangular mark on the processor carrier
and processor.
b. Install the heat sink onto the processor-carrier.
c. Press the carrier into place until the clips at all four corners engage.
Step 5. Install the processor-heat-sink module into the system board socket.
Figure 108. Installing a PHM
a. Rotate the anti-tilt wire bails inward.
b. Align the triangular mark and four Torx T30 nuts on the PHM with the triangular mark and
threaded posts of the processor socket; then, insert the PHM into the processor socket.
c. Rotate the anti-tilt wire bails outward until they engage with the hooks in the socket.
d. Fully tighten the Torx T30 nuts in the installation sequence shown on the heat-sink label.
Tighten the screws until they stop; then, visually inspect to make sure that there is no gap
between the screw shoulder beneath the heat sink and the processor socket. (For reference,
the torque required for the fasteners to fully tighten is 1.1 newton-meters, 10 inch-pounds).
After you finish
Complete the parts replacement. See "Complete the parts replacement" on page 224.

Rack latches replacement

Use this information to remove and install the rack latches.

Remove the rack latches

Use this information to remove the rack latches.
About this task
.
Chapter 4 Hardware replacement procedures
185