Install The 7Mm Drive Backplanes - Lenovo ThinkSystem SR630 Maintenance Manual

If you are instructed to return the old backplanes, follow all packaging instructions and use any packaging
materials that are provided.

Install the 7mm drive backplanes

Use this information to install the 7mm drive backplanes.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the new backplanes to any unpainted surface on
the outside of the server. Then, take the new backplanes out of the package and place them on a
static-protective surface.
Step 2. Install the 7mm drive backplane at the bottom.
Figure 48. 7mm drive backplane installation (bottom)
a. Align the pin on the cage and slightly slide the backplane into the cage until it is fully seated.
b. Install the screw as shown.
Step 3. Install the 7mm drive backplane on the top.
.
Chapter 4 Hardware replacement procedures
107