Install The Ocp 3.0 Ethernet Adapter - Lenovo ThinkSystem SR630 Maintenance Manual

• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Figure 95. OCP 3.0 Ethernet adapter removal
Step 1. Loosen the thumbscrew that secures the adapter.
Step 2. Pull out the OCP 3.0 Ethernet adapter by its handle on the left as shown.
After you finish
Install a new OCP 3.0 Ethernet adapter or a card filler. See "Install the OCP 3.0 Ethernet adapter" on page
172.

Install the OCP 3.0 Ethernet adapter

Use this information to install the OCP 3.0 Ethernet adapter.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the OCP 3.0 Ethernet adapter to any unpainted
surface on the outside of the server. Then, take the OCP 3.0 Ethernet adapter out of the package
and place it on a static-protective surface.
ThinkSystem SR630 V2 Maintenance Manual
172