Ocp 3.0 Ethernet Adapter Replacement; Remove The Ocp 3.0 Ethernet Adapter - Lenovo ThinkSystem SR630 Maintenance Manual

Step 5. Install the M.2 drive on the M.2 adapter.
Figure 94. M.2 drive installation
a. Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
b. Rotate the M.2 drive down until the notch
c. Slide the retainer forward (toward the connector) to secure the M.2 drive into place.
Step 6. Connect the cables to the M.2 adapter and system board. See "M.2 drive backplane" on page 62.
After you finish
1. Complete the parts replacement. See "Complete the parts replacement" on page 224.
2. Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID. For more information, see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_v3_about.html

OCP 3.0 Ethernet adapter replacement

Use this information to remove and install the OCP 3.0 Ethernet adapter.
Note: The OCP 3.0 Ethernet adapter is available only on some models.

Remove the OCP 3.0 Ethernet adapter

Use this information to remove the OCP 3.0 Ethernet adapter.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
catches on the lip of the retainer
1
.
Chapter 4 Hardware replacement procedures
.
2
171