Install The M.2 Adapter And M.2 Drive - Lenovo ThinkSystem SR630 Maintenance Manual

Note: The M.2 adapter you want to adjust might be different from the following illustrations, but the
adjustment method is the same.
Figure 91. M.2 retainer adjustment
Step 1. Press both sides of the retainers.
Step 2. Move the retainer forward until it is in the large opening of the keyhole.
Step 3. Take the retainer out of the keyhole.
Step 4. Insert the retainer into the correct keyhole into which the retainer should be installed to
accommodate the particular size of the M.2 drive you wish to install.
Step 5. Press both sides of the retainer.
Step 6. Slide the retainer backwards until it is seated in place.

Install the M.2 adapter and M.2 drive

Use this information to install the M.2 adapter and M.2 drive.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the M.2 adapter and M.2 drive to any unpainted
surface on the outside of the server. Then, take the M.2 adapter and M.2 drive out of the package
and place them on a static-protective surface.
Notes:
.
Chapter 4 Hardware replacement procedures
169