Install An Intrusion Switch - Lenovo ThinkSystem SR630 Maintenance Manual

• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Remove the top cover. See "Remove the top cover" on page 220.
Step 2. Disconnect the cable of the intrusion switch from the system board. For the location of the intrusion
switch connector and cable routing information, refer to "System board components" on page 44
and "Intrusion switch" on page 59.
Step 3. Slide the intrusion switch as shown to remove it.
Figure 84. Intrusion switch removal
After you finish
If you are instructed to return the old intrusion switch, follow all packaging instructions and use any
packaging materials that are provided.

Install an intrusion switch

Use this information to install an intrusion switch.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
.
Chapter 4 Hardware replacement procedures
147