Update The Machine Type And Serial; Number - Lenovo ThinkSystem SR630 Maintenance Manual

• "RAID super capacitor modules" on page 189
• "Riser assemblies" on page 198
• "CMOS battery" on page 108
• "OCP 3.0 Ethernet adapter" on page 171
2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component in Chapter 3 "Internal cable routing" on page 55.
3. Install the rear drive cage if you have removed it. See "Install the hot-swap rear drive assembly" on page
141.
4. Install the air baffle if you have removed it. See "Install the air baffle" on page 92.
5. Install the top cover. See "Install the top cover" on page 222.
6. Push the power supplies into the bays until they click into place.
7. Connect power cords to the server and turn on the server.
8. Update the machine type and serial number of the system board. See "Update the machine type and
serial number" on page 216.
9. Enable TPM. See "Enable TPM" on page 218.
10. Optionally, enable Secure Boot. See "Enable UEFI Secure Boot" on page 219.
Update the machine type and serial number
After the system board is replaced by trained service technicians, the machine type and serial number must
be updated.
There are two methods available to update the machine type and serial number:
• From Lenovo XClarity Provisioning Manager V3
To update the machine type and serial number from Lenovo XClarity Provisioning Manager V3:
1. Start the server and press F1 to display the Lenovo XClarity Provisioning Manager V3 interface.
2. If the power-on Administrator password is required, enter the password.
3. From the System Summary page, click Update VPD.
4. Update the machine type and serial number.
• From Lenovo XClarity Essentials OneCLI
Lenovo XClarity Essentials OneCLI sets the machine type and serial number in the Lenovo XClarity
Controller. Select one of the following methods to access the Lenovo XClarity Controller and set the
machine type and serial number:
– Operate from the target system, such as LAN or keyboard console style (KCS) access
– Remote access to the target system (TCP/IP based)
To update the machine type and serial number from Lenovo XClarity Essentials OneCLI:
1. Download and install Lenovo XClarity Essentials OneCLI.
To download Lenovo XClarity Essentials OneCLI, go to the following site:
https://datacentersupport.lenovo.com/solutions/HT116433
2. Copy and unpack the OneCLI package, which also includes other required files, to the server. Make
sure that you unpack the OneCLI and the required files to the same directory.
3. After you have Lenovo XClarity Essentials OneCLI in place, type the following commands to set the
machine type and serial number:
ThinkSystem SR630 V2 Maintenance Manual
216