Remove The Front 3.5-Inch Drive Backplane - Lenovo ThinkSystem SR630 Maintenance Manual

Step 3. Align the two pins on the backplane with the corresponding holes in the chassis.
Figure 37. Installation of backplane for ten 2.5-inch hot-swap drives
Step 4. Lower the backplane into the chassis. Ensure that the pins pass through the holes and the
backplane is fully seated in place.
Step 5. Connect the cables to the system board or expansion slots. See "2.5-inch/3.5-inch drive backplane
(power)" on page 65 and "2.5-inch/3.5-inch drive backplane (signal)" on page 66.
After you finish
1. Reinstall all the drives and drive fillers into the drive bays. See "Install a 2.5/3.5-inch hot-swap drive" on
page 125.
2. Complete the parts replacement. See "Complete the parts replacement" on page 224.

Remove the front 3.5-inch drive backplane

Use this information to remove the front 3.5-inch drive backplane.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
ThinkSystem SR630 V2 Maintenance Manual
96